Cisco Optical Technology Advanced (OPT300)

Detailed Course Outline

• Module 1: Cisco Transport Planner (CTP) Design Tool
• Module 2: Cisco Transport Controller (CTC) Operations
• Module 3: WSS- and WXC-Based Mesh Networks
• Module 4: Node Turn- Up: 40/80 WXC Mesh Technology
• Module 5: Install Circuits and View Power Levels in WSS and WXC Networks
• Module 6: SMR-Based Network and Node Turn-Up
• Module 7: Install Circuits and View Power Levels in SMR1 and 2 Networks
• Module 8: G.709 Encapsulation and 10G Transponders and Encapsulation Options
• Module 9: 10 Gigabit Transponders
• Module 10: Generic Framing Protocol G.7041 and 10G Data Multiplexer Enhanced Cards and Encapsulation Options
• Module 11: Any-Rate Muxponder and Crossponder Cards
• Module 12: Ethernet and VLANs
• Module 13: 10 GE-XP and GE-XP Enhanced Cards, Settings, and Circuits Layer 1
• Module 14: Quality of Service
• Module 15: Layer 2 XP-E Cards Protected Ring, CoS Marking by Port, Customer VLAN, and QoS
• Module 16: T1 over Ethernet and Ethernet over T1 in Crossponder Network
• Module 17: 100G Transponder and Muxponder Installation and Circuits
• Module 18: 10G Encryption Card
• Module 19: Add-a-Node Design and Installation
• Module 20: ONS 15454 MSTP Troubleshooting

Lab Outline

• Lab 1: Start the Cisco Transport Planner Software and Create a DWDM Network
• Lab 2: Configure Cisco Transport Controller and Display Network
• Lab 3: Establish 4-Node 40- and 80-Channel Mesh Networks
• Lab 4: Create Circuits and View Power Levels in 40 and 80 WXC Networks
• Lab 5: Establish Six-Node SMR1 and SMR2 Mesh Networks
• Lab 6: Create Circuits and view Power levels in SMR1 and 2 Networks
• Lab 7: Establish 10G Transponder Circuits
• Lab 8: Any Rate Muxponder and Crossponder Options 8:2 configuration
• Lab 9: 1G and 10G Crossponder Layer 1 Network
• Lab 10: 1G and 10G Enhanced CrossPonder Layer Two-Ring Configuration
• Lab 11: Circuits to Carry T1 over Ethernet
• Lab 12: 100 Gigabit Transponders and 10 x 10 Muxponders
• Lab 13: 10G Encryption Card Circuit
• Lab 14: Add-a-Node to Six-Node Mesh Network
• Lab 15: MSTP Troubleshooting